SpinTrim: Rubber Deflashing Machine

The Barwell SpinTrim is a simple and cost-effective method of deflashing small rubber parts. It can be used as a single process operation or as a cost reducing first stage before cryogenic deflashing for excessive flash.

• An affordable system of mechanically deflashing rubber parts that provides quick pay back & improved finish quality
• A very compact and quick solution for the deflashing of rubber parts
• A simple method of operation and exceptionally easy to maintain
• A system that eliminates safety risk and time taken with manual trimming

When should I use the SpinTrim?
The SpinTrim is ideal for the high quality deflashing of small to medium size rubber parts that do not have excessive flashing or for more excessively flashed product when the application does not require a pristine finish.

It separates the sprue and the unwanted flash surrounding the product in a short period of time (usually about a minute). It offers considerable cost, time and quality and safety advantages over hand-cutting, grinding, chemical or tumbling methods of deflashing.

However, it is also a cost-effective first stage process for the deflashing of more complex parts or those that have excessive flash prior to using a Barwell Freeze Trim cryogenic deflashing machine. The benefit of having a two-stage process is that it reduces the time taken during cryogenic deflashing including the amount of nitrogen used - reducing operational costs. It also means that a higher quality part is produced as the cryogenic and media blasting process can concentrate on polishing and fine trimming the parts.

Take-off waste separator now also available
The separator has 14 perforated sheets of differing hole sizes so you can set the separator up for each product. The upper sheet allows the good parts and small flash to fall through. The lower sheet then allows this flash to fall to the bottom, leaving the deflashed parts in the middle of the separator. Boxes at the end collect the deflashed parts and flash. The large flash is manually removed for the upper sheet by hand or vacuum.

This optional extra will save labour time and cost in sorting out the parts, and is compact and very efficient and simple to operate. See it in action here.

Features

• Capacity 14L (usable volume 4L)
• For loads of a maximum of 1 kg
• Up to 7000 rpm spin speed
• Adjustable cycle time
• Supplied with 7 vacuum screening plates for process flexibility
• High quality Omron PLC and inverter
• Multi-language colour operator interface angled for easy viewing
• Stores up to 20 process set-ups
• Insulated for sound reduction
• Take-off separator available as optional extra
• CE compliant 

Technical Specification

Dimensions	Length: 1700 mm Width: 550 mm Height: 1100 mm
Weight	310 kg
Power Supply	380V-440V 3 phase, neutral and earth. Total maximum connected load 5kW. 220V single phase for the vacuum machine
Air Supply	1/4” BSP Maximum permissible pressure of 85 psi
Capacity Size	14L (maximum chamber fill 4L)
Maximum rpm	7000 rpm

 

Send a product enquiry »

Download Catalog »

Product catelog